need pics of your warp setup.

[tl1000s]

Alright, I've got a new (used) warp now, with a revy that's been drilled for the hose to pass through, but I need some ideas on the best way to set it up. Can you guys post pics of your setup to help me out?

[BlackVCG]

This is a left handed setup, but it's basically the same thing, just reverse everything.

[tl1000s]

thanks! anybody else? especially a pic of a PTP warp.

[dyerules]

Hey balck I was just wondering w/ having the tube run through your hopper in back of the slant on the revvy will any balls go past the point of where the hose is??

Thanks!!!

[Bartleby]

here's one that's melted (rather poorly too ) just to give you an idea of some alternatives.

[snakestang]

Not even close to being as clean or smooth as BlackVCG but here is mine. And as far as the hose goes, if you add a tad extra on the length it will bow out inside the hopper so paint can flow around the tube.

[Army]

Here's mine. It has a red Gem Revvy and an 8" Taso now, but it's still set up the same way:

[Bartleby]

alright after seein all these pics of holes i'm definitely gonna get another shell and do the same...

[tl1000s]

thanks

thanks for all the pics guys! it's a great help, keep em coming. I have two revy shells, but both have been drilled already in a spot that I don't want the hole. I think I'll try to patch the hole up, and re-dremel the top hole in the spot I want. I have a cut feed tube (previous owner) so I can't set it up the way I've seen a bunch of them setup.

[hitech]

There is a pic of mine in my sig.

[MrMag]

quick question.........if i am right handed, what type of body do i want to run warp? hopper right or left?

[surfer349]

hey,
i am getting a warp soon, and am wondering, does it really matter if the tube is melted into, or drilled through the hopper? like does it allow the setup to be place closer to the gun?

[davej946]

As soon as I get a digital camera that works (mine washes everything out) I'll get you a pic of mine.

Later ~ Dave

[Schnitzel]

if you're right-handed, go with hopper right. it puts the warp on the left side of the marker with the shortest hose line-to-powerfeed as possible.

if you're left-handed, go with hopper left.

[hitech]

Originally posted by surfer349
hey,
i am getting a warp soon, and am wondering, does it really matter if the tube is melted into, or drilled through the hopper? like does it allow the setup to be place closer to the gun?

It makes for a "cleaner" setup, and it helps holt the hopper in place. Besides, I think drilling is actually easier.