Shot my Blot into my Barrel??

[projekt23]

Has anyone ever seen this or done it??

I was playing this last weekend and out of no where my gun stoped working.. upon getting off the field I noticed that my blot was inside of my barrel (used a pool cue to knock it out) What may have caused this all opinions welcome..

thanks

[codeJockey]

Ummm... What the heck is a blot?

[projekt23]

hahaha - bolt, my bad...

[petefol]

what kind of bolt was it, im guessing a 3rd party one?

[TefMag68]

There was a thread posted on here months ago about the same problem. It's very rare and quite honestly I don't see how it could happen without something breaking(either the back of the bolt or the ring inside your main body) I dunno what else to say. good luck

[Mav D MagMan]

Well the automag bolt does travel into the barrel during it's cycle, also bolts can be machined at a different outter diameter than that of the inside of the barrel (ask Miscue bout this one)

Anyways if the bolt doesn't fit well, you get problems, that's why it's a good idea to try a new bolt to your barrel before you use it (or vise versa)

Mav

[projekt23]

I am using the stock minimag bolt, nothing moded at all.. I had never seen this before and was amazed when we found out what had happened... oh this was with the J&J Ceramic...

[Miscue]

I had same problem with L10 bolt and a tight bore barrel. Spring was completely compressed... bolt stuck. Had to tap it out with screw driver and it shot out at 30mph.

Solution: Don't use that barrel. If it's getting caught on the tip... you can carefully sand down the tip.

[bornl33t]

seems that some ppl still use the wire "P" nubbins.. they bend over and cause a jam... course they are shot afterwards.. but
Dunno if this is what happened?

[Gadget]

I've had this happen before and like Heat said, it was a wire nubbin causing the problem - I must have bent it into the barrel slightly too far and the bolt caught it and wrapped the whole end round into the barrel, jamming the bolt.

[xmetal2001]

Weird. Sorta sux that if it gets stuck in your barrel you have to get a new barrel, i didn't think it was that tight of a fit. I guess on a very tight bore barrel...