if i get a new vibe sensor should i get new springs as well? do old ones ahve any impact on the sensor itself?
-
-
Quick set up help?
I just got a used warp. I have the mounting bracket, but no hoses. I have a VL Revolution loader. Eventually I'd like to get it dialed in just right, but for now I just want it to work so I can see what's going on. I put a battery in it and it works. What diameter hose does it take?
I'm also trying to trouble shoot the revi. I bought new batteries and I took it apart. The red 'on' light comes on but nothing spins. Can I buy a new servo at radio shack? How do I check to see if the sensor or board is still functioning and where can I get a new one if I need it?
Thanks in advance,
Gabe.Comment
-
Rotor on a warp
I am just got a warpfeed and noticed that the rotor feed neck is to big for the warpfeed. Should I file down the feedneck the warp shell or loosen the upper shell screws and then tighten with the rotor in placeComment
-
I never tried a rotor in a warp. How much bigger is the neck of the rotor than the feed hole in the warp? If there isn't much difference in size, loosening the screws will work. If there is considerable size difference, all you will do is crack the warp shell when you try to tighten the case screws. Its probably best to sand down the rotor feed neck or get an a adapter.Originally posted by Syko89Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
^^ This.Originally posted by athomas
I use a Rotor with my warpfeed all the time. Just barely loosen the two screws around where the hopper attaches, and then finger-tight snug them back down. It'll work like a champ. (The Rotor feedneck will eventually take some wear anyway)Comment
-
vibe sensor or intelli switch
get my warp setup running on a tac one with a ninja shp 1100 psi reg. just got lukes 12v mod in and i was wondering if the intelli switch or the vibe sensor would be better for it. vide sensor works just fine but was something i was wondering aboutComment
Comment