Argh: Emag chopping

[punkcmonkiez]

take out the nubbin**

[athomas]

What is the type and inside diameter of the barrel that is being used?

[alee@usma]

barrel is not the problem.

I know the barrel's not the problem. I have 2 barrels I was using. A boa snakebite 10" and the stock emag barrel. Chopped bad with both.

[toymyster]

I know it may sound redundant, but have you checked the dwell on your warp yet?? Or try disconnecting the warp, and just gravity feeding from the hopper and see if it's chopping!! If the problem goes away, then you know it's the warp, if not, we'll look at other stuff (not much left)!!! Hope this helps!!!

[athomas]

It may just be a cursed emag. Mine chopped when I fired rapidly. I set the rate of fire down to 9. It helped but I wanted the full speed of the emag.

Mine emag had a sn in the 300's. How old is the one you have that is chopping? Maybe there was a manufacturing problem with something not lining up. Its the only thing I can think of.

I installed the LX and haven't had a problem since, so I don't care anymore. Get the LX.

[sneakyhacker420]

sometimes, the warp feed hose will have a bend in it that the balls just don't like to feed past very fast

i have had this same problem before on my minimag, also, APG had this problem while testing/reviewing the micro emag

get some new hose and try and run a diff. path or something

check to see if the PF plug is in all the way and is straight, and make sure the warp has fresh batteries and it spins 1/4 to 1/2 turn every time you shoot.... if its not turning, adjust the sensitivity




i said a mouthful, but one of thoes should hopefully fix the problem