cutting my macros

[Mag Master 04]

what should i use to cut my macros down to size and still have both ends smooth and clean not chopped up and not sealing all the way, i uses some pliers w a blade in them but its not a clean edge and it made it so it leaks in the fitting...HELP

[covadsucks]

Just get a very solid and sharp knife and press down slowly against a solid tabletop or benchtop or even a cutting board. Try not to let the macro roll under the blade or you run the risk of a sloppy cut and cutting your fingers.

[magerman52]

the best thing ever invented for cutting things like macro micro wire and anything small and round is dikes they are the best!

[Tunaman]

DO NOT USE DYKES TO CUT MACRO! Use a Macro Cutter! I have them. Email me

[magerman52]

why not use dikes i used them and my macro works great no leaks. and i had no leaks when i used it on my micro.

[edboe]

straight Blade razor

I always use a straight blade razor, just put the line on a flat surface and push down to cut a nice clean edge. $3 for a 5 pack at home depot. I use them for weeding vinyl. I have a sign shop at my house.

Ed

[mobius]

When cutting macro, I have always used a hacksaw with a very fine toothed blade. It works great.

[spacedtedybear]

I use sharp wire cutters. It went straight through the macro without any problems.

[ShooterJM]

Hacksaw or a ginsu bread knife. Then clean with razor if need be. But I don't have to do it often...

[Kevmaster]

no

Tuna's Macro cutter...OR a Razor/ExactO knife. DONT use a hacksaw or wire cutters...that will not leave nearly as clean edges

[Mag Master 04]

thanks guys i used a fatty steak knife...i wanna see a macro cuter tuna i emailed u

[Tunaman]

Here is the pic...

macrocutter

[Mag Master 04]

hmmm

link aint workin...