Tolerance Specifications - E-Mag - RT-Pro - Minimag/Automag - Level 10

[superfreakmabsta]

loctite

[hill160881]

my specs

Gun and specs
minimag/ x-valve/ intella frame/ 12v warp feed/ dynaflow adjustable hp reg

-on/off assembly has upper quadring

-on/off pin .735 due to the quadring and desired rapid response trigger feel. .740 would not cycle and .725 was leaky and way to fast.

-Level X bolt(not really a big fan but i keep trying. I should run a roto, no warp and a level 7)

-input pressure 950psi at 13bps(estimation)
-input pressure 1100psi at 18+bps
-if problems occur go back to all stock specs( this includes the level 7 bolt and use the specs from AGD). if problem is solved then start rebuilding the marker piece at a time till the problem retuns. if problem prissiest then the gun has ben modified in some way to change the tolerances like a paint job instead of anno, or something.
hope this helps someone

[madcrisis]

how do you kno which on off pin to use? is the the valve or the rail or body?