OUCH! Warp Feed is pinching my balls!!

[EvilErnie]

I went out this weekend to play with some friends of mine and I had just bought a WARP FEED for my RT. When I hooked it up and loaded it, I noticed that the balls were a little tight at the 90 degree adapter. We played the first game and I could not get the WARP to feed any balls. I put fresh batteries in the feed and my VL, I had to push the balls down the power feed with my finger. Any help on what I can do to relieve the pressure on my balls? Stop laughing...its not funny!

[BlackVCG]

Take the hose off the adapter and with the hopper full and batteries in both the hopper and Warp, press the primer button and cycle some paint through the Warp and make sure it feeds out the end of the hose without binding up. If it dumps paint out fast, the problem is in the 90 degree adapter or your PF. Make sure the PF plug is positioned properly in the 90 degree adapter and in the PF. You can also put the 90 back on the hose adapter and run paint through and see if it's binding at the curve. If so, back out the PF plug a bit with the set screws. Also, if you don't have a parabolic PF plug in both your 90 adapter and the PF on the gun, that could be the problem. Check these two threads and see if they help you. You can NOT use the old style PF plug with the Warp. You need to have the parabolic PF plug.

http://www.automags.org/forums/showthread.php?threadid=12140

http://www.automags.org/forums/showthread.php?threadid=12911

[EvilErnie]

I know the balls flow freely without the 90 on the tube, so the problem must be with the PF plug, thanks for the info! I'm sure my balls will thank you as well! LOL