ok, when i hold the gun (with out air) upside down(so the trigger pushes back easier) it works perfectly, then when there is air it stays on sometimes, and also if i tap the hopper, or move it quickly the impellar spins. the jmj impeller is amazing, i made my hopper a 18, but then stopped cause its probly dab for the motor.:)
-
-
you probebly need to adjust the microswitch a little bit. those are really sensitive. getting the switch arm bent just right can take some time. you just have it a little to close to perfect. back it off a little.
"super multi-green mag" Cp barrels, LX bolt, no-rise, intelli, 47ci flatline, halo................
Red dragun body, turbo valve, 12" Boomstick, Spud magics anti-chop bolt with quickstrip, ELCD, nitroduck 68CI,Gas thru stock, 12V revy, AGD Warpfeed system
Xen's paintball pages -
Do you have to bend the switch arm?
I had the same problem. I couldn't tell whether positioning the switch on the mountholes or bending the arm was the best way.
As a side note, has anyone else accidently cut through the "red" wire on the revy when trying to strip back the insulation? WHOOOPSIE! Used a soldering iron to repair but dang, that ticked me off!Comment
-
I bent the arm up on my switch..........gave the best reliablility
"super multi-green mag" Cp barrels, LX bolt, no-rise, intelli, 47ci flatline, halo................
Red dragun body, turbo valve, 12" Boomstick, Spud magics anti-chop bolt with quickstrip, ELCD, nitroduck 68CI,Gas thru stock, 12V revy, AGD Warpfeed system
Xen's paintball pagesComment
Comment