i-feed

[jcoolzer0]

ok, when i hold the gun (with out air) upside down(so the trigger pushes back easier) it works perfectly, then when there is air it stays on sometimes, and also if i tap the hopper, or move it quickly the impellar spins. the jmj impeller is amazing, i made my hopper a 18, but then stopped cause its probly dab for the motor.

[xen_100]

you probebly need to adjust the microswitch a little bit. those are really sensitive. getting the switch arm bent just right can take some time. you just have it a little to close to perfect. back it off a little.

[Sputnik]

Do you have to bend the switch arm?

I had the same problem. I couldn't tell whether positioning the switch on the mountholes or bending the arm was the best way.

As a side note, has anyone else accidently cut through the "red" wire on the revy when trying to strip back the insulation? WHOOOPSIE! Used a soldering iron to repair but dang, that ticked me off!

[xen_100]

I bent the arm up on my switch..........gave the best reliablility