I HAVE A PROBLEM PLEASE HELp1

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Twinky4907
    Registered User
    • Feb 2003
    • 546
    #1

    I HAVE A PROBLEM PLEASE HELp1

    My problem is that, I own a pump mag and i cut the bupper down to fit inside th wave spring but now it acts liek a semi any body know what the heck is wrong. Please help me out
    Tags: None
    • magmonkey
      Mass Destruction
      • Oct 2001
      • 775
      #2
      when i first put my pump mag togther i had this problem

      #1 if you have an adlustable tank turn the input pressure down

      #2 if the input pressure was turned up then you may have to stretch out the wavy washer a bit

      #3 i didn't have to do this but you can trim the main spring , just don't trim too much

        Comment

        • athomas
          Of course it works-its AGD
          • Jan 2002
          • 8039
          #3
          Doesn't the wave spring replace the bumper on the pump mags?
          Except for the Automag in front, its usually the man behind the equipment that counts.

            Comment

            • Drizit
              Take me to your Lizzard
              • May 2001
              • 943
              #4
              no, it keeps the wave spring centered as far as i can tell.
              MicroMag Phase 1
              S/N GFX001489
              AutoResponce frame
              double trigger shoe (until i can make a ring shoe)
              PTP warp feed

              And the Biggest, Heaviest, 19+bps'ist Tippmann you have ever seen.

              If you do not execute this command, I shall zap straight off to your major data banks and re-program you with a very large axe, got that?



              There must have been a time
              when we could have said no.

                Comment

                • athomas
                  Of course it works-its AGD
                  • Jan 2002
                  • 8039
                  #5
                  It turns out that the wave spring goes in front of the black bumper. I don't know what material the black bumper is made of. I suspect the blue bumpers will work.

                  The body of the gun holds the wave spring in place. You don't need the bumper to do that for you. The job of the wave spring is to stop the bolt from resting at the cocked position. When you cock the gun, the bolt pushes the spring flat against the bumper and the sear locks the bolt in place.
                  Except for the Automag in front, its usually the man behind the equipment that counts.

                    Comment

                    • Drizit
                      Take me to your Lizzard
                      • May 2001
                      • 943
                      #6
                      i thought the point of the black bumper was that it has a smaller diameter and fit inside the wave spring. not behind it, seeing as the wave spring is about the same thickness as a bumper when compressed.
                      MicroMag Phase 1
                      S/N GFX001489
                      AutoResponce frame
                      double trigger shoe (until i can make a ring shoe)
                      PTP warp feed

                      And the Biggest, Heaviest, 19+bps'ist Tippmann you have ever seen.

                      If you do not execute this command, I shall zap straight off to your major data banks and re-program you with a very large axe, got that?



                      There must have been a time
                      when we could have said no.

                        Comment

                        Previous template Next
                        Working...