//\\//\\ How to build a mag.//\\//\\ Guide

[GT]

[GT]

For used parts particularly anything that will have an air connection make sure that are very very clean. Go to your favorite hardware store and buy a set of dental pics. Take the dental pics and clean every single thread.

7. a note on Teflon tape this stuff is only good if you are in a bind. It can be a real mess if you have not used it before. It is good to take to the field for emergencies but beyond that it can cause more harm than good. However the best way, I believe is to wrap the air fitting twice with a very even thinTake home message: this stuff can be nasty avoid use if possible.

[GT]

How to build a mag, finally!
<a href="http://underconstruction.typepad.com/home_sweet_home/fb9bd6cc.jpg"><img alt="fb9bd6cc.jpg" src="http://underconstruction.typepad.com/home_sweet_home/fb9bd6cc-thumb.jpg" width="450" height="301" border="0" /></a>


Click above picture for the uber huge picture!!!IT DOES NOT NEED TO BE SO TIGHT THAT IT MAKES YOUR NUCKLES WHITE!

7. Connect the rest of your air fittings using the BL method.

8. Bolt on your ASA, dropforward, and tank

9. Screw in your barrel, place hopper on body, connect airlines, gas up and OWN!

10. Done!

[GT]

put on a barrel condom or plug tape a paintball half way into the breech. Pull the trigger until the paintball gets chopped. IF you run out of air, your hand gets tired then the lvl 10 is setup properly. If not start over with the above steps.

[rdb123]

Great thread. Link to big pic doesn't work though.

[GT]

I need someone to host it. Its really really nice

[GT]

any comments guys?

jb

[MethodGZ]

What great timing. I posted something like this about two years ago...before the ULE, Before XValve, hell, before just about everything. Anyways, I'm back to the mag world, and I was gonna post something like this, but hell, you just saved me a lot of time, and did it better.

Good job.

- Method

[stondroopy]

hmm i think i could do that

[sk8bordr706]

i can probably host it for u, do u have mirc?

[GT]

pic hosted thanks guys link under smaller pic.

jb

[Lefty]

Good description. towel, pink

LOL!

[impulsed329]

hey was how much would ALL that cost, but substitute the yframe for an intelli blade in chrome and no speter kit either

[Morfesto]

You did a great job, anyone should be able to assemble a mag after reading that.

[GT]

Thanks a bunch guys. As far as cost just head to the AGD store and start addidng!