Parts Kit Installation Guide?

[Dayspring]

I'll ask Tom/Jon this weekend and see if there's a diagram for one.

[natgry]

hi, I'm new to the forums and I'm pretty new to automags, but I've been reading all the threads on leaks and rebuilding, and this one seemed the most relevant/helpful to post in...

I have a 68 classic, with the classic valve and a level 10 bolt. when I gas up, there's a leak out the back (coming from the velocity adjuster), and when I hold the trigger down, it continues to leak out the back. by turning down the velocity adjuster (to about 150-170) will stop the leak temporarily, but eventually the velocity creeps and the leak starts up again. everything else functions properly, and the gun can be shot without problems even while it is leaking. reading through other threads about leaks here, I figured it was probably either the regulator seat or the regulator piston o-ring. so I took the valve apart and checked both, but they both appear to be in good condition (regulator seat doesn't have pits and isn't worn out or punched off center, and the regulator piston o-ring is lubed up just fine and doesn't suffer from compression problems and appears to be nice and tight on the piston).

are there other problems that might be occuring? are there any parts I should try replacing?

any help is greatly appreciated.