Warp Feed Doesnt Stop Spining

[Havoc_online]

Don't know, vibe sensor worked fine before I sent it to Havoc, came back from him yea it stopped continuous spinning but now it needs an intellilink I dont have

If it worked fine, why did you send it to me?
Your shell is messed up, thats why it didnt work in Vib.

[cr@ckhead]

how much power can a ricochet 2k board take?

since my warp board is messed up, i'm just going to bypass it.

my idea is to run the warp using the rico sensor. i will tap the wires running to the little rico motor and have them run to the warp motor.
i just need to know how much juice a rico board can take. i don't want to fry that sh1t up.

[speedyejl]

If it worked fine, why did you send it to me?
Your shell is messed up, thats why it didnt work in Vib.

Didn't mean to imply it was any fault of your own,

The vibe sensor worked fine before the continuous spinning issue. Connecting the Matrix noid apparantly caused the spinning error. But the vibe sensor was working fine before that. I'll post it in B/S/T eventually and it'll find a home with someone who can intellilink it.

[Havoc_online]

Just wanted to clarify, got confused because as far as I knew you were happy with what I did. I tried my best to get the vib to work aswell, but it just wouldnt work reliably. Sorry for the fuss.

[cr@ckhead]

how much? i might buy it. i really just need the board.

also:

[lamby]

if you are having a problem with the warp spinning non-stop after a mod (12vdc) you will have to place two filter caps in the circuit. Use 20-25vdc 47uf caps and place the - to the ground and the positives on the +18vdc and +12vdc. It will look sorta like this... The warps are not filtered well and modifations make them act up.