how do you take out your double trigger and instal the tl-63 blade trigger??
-
-
up, plz someone help me and tell me how to take the double trigger out -
Put the selector in E.
With a punch of a smaller diameter than the pin,drive out the trigger pin towards the selector side of the gun.You may have to remove the body/rail to get the trigger out around the trigger rod.
Repeat in reverse order with new trigger.
Jay.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
-
what is a punch, do you mean? I have tried to tap it out with a nail with no sucess, do you have any other ideas or things to use? thanksComment
-
A punch is like a nail set or like a screw driver that's round on one end,just like the pin,and is wide enough at the other to hammer.Support the gun firmly and it'll take a good wack to get it going. BE CAREFUL.
Something like this^^^^^^Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
-
Also that orginal pin is machine pressed into place. Once you get a proper punch as pictured by RFfireblade you'll need to have a big wieghty hammer or be prepared to really lay into it with a lesser hammer. I tried using a phillips screw driver at first...yeah that didn't work for me, I bent the screwdriver. Just be very dilberate when striking the punch becuase one slip and you'll have a custom engraved Anno job on your Trigger frame. Good luck BD21.- JPM -
Comment
Comment