Still having problems with my viking

[CaliWagon31]

Ok,

I got this viking in a trade. I tried to fire it and it will fore on the first shot, but every shot after it wont cycle. The bolt isnt going all the way back so it can cycle again. I have increased the pressure and decreased the pressure on the sidewinder, but not the pressure system on the gun. If anyone could help me with this, I would be greatly appreciated. I can get a video of it shotting (or doing what it is doing if that would help)

[GT]

turn up the dwell

[CaliWagon31]

how do i do that on the stock board?

we also noticed that after the forst cycle goes off, that the bolt pin jumps up a little and doesnt stay in good contact with hammer. Also, is the bolt supposed to have a little mechanism inside of it or something, i say it on the little manual, but i didnt see it on my actual bolt.

[Jon/xpm]

CaliWagon31-best thing to do is call AKA
Bolt could be backwards or maybe having the lpr very low
But this is a guess
If you do not want to wait to call AKA tommorow
aka section on pbnation is very helpful
Thanks
Jon/xpm

[CaliWagon31]

alright, thanks for the help, i will try that tomorrow

[Ov3rmind]

Originally posted by CaliWagon31
we also noticed that after the forst cycle goes off, that the bolt pin jumps up a little and doesnt stay in good contact with hammer. Also, is the bolt supposed to have a little mechanism inside of it or something, i say it on the little manual, but i didnt see it on my actual bolt.

The bolt pin should be held in by a ball bearing. If your pin is jumping up, tighten the screw inside the bolt (when you're looking down the back of the gun, there should be a slot for a flat head screwdriver in the bolt).

[dinger]

turn up the dwell
increase lpr

my guess is not enough flow to get the bolt back.