I finally got my lvl 10 to work. It has the 1 notch carrier, 3 shims, and the medium spring. But after doing some tests, I noticed that it still has the tendency to chop a ball 1/2 way into the chamber. What should I change to make the lvl 10 not do this?
-
-
Move to the longest spring to further soften the level 10.Except for the Automag in front, its usually the man behind the equipment that counts. -
use the biggest carrier that doesnt leak, and a little shims as you can get away with. Then as a last resort, goto the longest spring.Comment
-
i also noticed with my current setup that sometimesn when i pulled the trigger it "chuffed" as in the bolt would only go foward about 1 cm and go backComment
-
get a faster hopper, use fresh paint.
If the bolt is venting sometimes from just the force of the spring, but is still able to chop a ball other times that may due to the oring drying out, keep it greased.
to really get the LX tuned to not chop, you can use the largest spring or a tighter/smaller carrier, or both, but It dosen't sound like yours is working consistently enough for those kinds of changes yetComment
Comment