IntelliFeed help with Warp and Hoppers - Rob?

[Dubstar112]

I have a hyperframe, and theres a microswitch for the trigger just like the one I used in my intelliframe... if i use the same jumper setting for thr warp and connect a wire to the hyperframe micro switch it should work just like the intelliframe right?

[RT_Luver]

Is there a way to intellink the warp and HALO from the intelliframe?it'd make it much easier then having to adjust the sensor everytime.

[RobAGD]

Ah you dont really want to link the halo, it run on every shot of the gun as it is.

And you shouldnt have to adjust your pot setting everytime as long as you use good batteries.

-Robert

[Tufiremn]

Warp feed help

Try this site. He has pictures and instructions for the dual battery mod, and on/off switch. I have both of these on my warp, done by Petty himself. BTW, Warps can't handle 18v, read the instructions that came with it, it says that 18v will hurt the board / motor.http://www.pettypb.com/main.html

[Linkage]

Guys, I have an 68Automag and I want to change the main body from the standard body to either the powerfeed or warp feed bodies....I'd prefer to buy the warp feed body , but I don't own a warp feed yet and I'm not sure when and if I will. So I don't want to have buy another body down the road.

So here's my point. Can the Warp feed Main body work with out the warp feed,....i.e. just a regular loader.

Or...will the Warpfeed loader work with the powerfeed main bodies.

[gain_man]

i have my old school 9v running intellefeed off of my warp without paying any extra money

first i cut the circuit out of my revv, so its just the motor.

i soldered some wires from the warp motor, not the board, to the revv motor. so know whenever the warp spins, which is running intellifeed on my emag, the revv spins too. they both get 12v to them because the two motors are in parralell.

of course, that would drain 9v in an instant, so i have them powered off of my emag battery (thanks rob)

here is a quick explenation, and some pics. i didnt just run a straight wire, i made nice phono plug outlets and stuff, thats the nice white cord that you see running, it came out really good.

[ANTHONY INCANTALUPO]

CONNECT WARP FEED TO e-mAG

I WANT TO KNOW IF I CAN HOOK-UP THE WARP RELAY I PURCHASED FROM AGD INTO MY E-MAG HOW DO YOU DO IT? OR DO I HAVE TO BUY AND ADDIONAL PARTS.