HUGE PROBLEM: Tank+to much pressure+gun wont fire= how to release PSI?

[Flow_Tech]

uhh..you could just unwrench the fitting a littlebit on the valve and let air seap out..

[Flow_Tech]

or just back the input out all the way till it leaks out.

[_KFC_Chicken_]

alright so do this...take the macro line in your hand..and cut it or put a small hole into it to drain the air...with the macroline in your hand it wont go flipping around...itll just cause a reallly loud sound...dood man that's ur only option because your mag wont fire...so you can drain the air that way....

do it like this

1) turn off the tank...set the input to 0psi
2) hold macro line valve end
3) cut the macro line ...and just hold it...there's approximately 1200 psi to bleed ...

what's the worse macro line can do when its clamped down by your hand..

1 you wont be able to hold onto a macroline with that much pressure



Ok, few more questions be4 I make me final decision.

1. Backing the small screw in the tip all the way out is to turn it down?EDIT IN THE ARMAGEDDON TAKN REGULATOR
2. If I was to unscrew the input guage, would it slowly leak? Or would it blow off? I have never done it, and my guess is there is to much sealent and not enough threads on it to create a leak?

[elprup]

Just out of curiousity, what was incorrect with the on/off?

[chirogator]

whew!

Yeahhhhhhhhh!

Now you can play paintball with all your friends!

Glad you still have all your fingers!

[_KFC_Chicken_]

Just out of curiousity, what was incorrect with the on/off?

The guy before me or the guy b4 him put 1 to many o-rings on the bottom. theres only supposed to be one small one, theres was small+large.