Emag Problem :(

[RogueFactoryKid]

Ok so i aired up my emag today and what happened surprised me, The bolt goes into autofire mode and the only way i turned it off was turning off the air.

[Dayspring]

Check your on/off pin length. You may have chopped it.

[RogueFactoryKid]

My who diddle what now? It worked fine less than a week ago, the only thing i changed was i switched from steel line to macro line. I dont know much about e-mags/ mag valves in general. Get back to me please, i have a scenario this weekend and i dont wanna be stuck with a tippmann or something

[toymyster]

Switching lines wouldn't do that!!! Overhaul your valve, making sure the on/off pin is still intact!! Go here for the specs: http://www.automags.org/forums/showthread.php?t=67604
Make sure nothing else in there is broken, clean and oil everything really well, and reassemble everything back together, that should take care of it!!! While you're at it, it doensn't hurt to replace all the seals and o-rings too!!! Hope thins helps!!!

[viperx1_1000]

what valve where you using because you have to switch the on/off if your using the classic valve.

[GordDesigns]

Also give a good look inside your regulator and valve area. You may have some left over sealant from the fitting or teflon tape that may have got into the gun.

[athomas]

Full auto is a symptom of worn or out of place parts. Like mentioned before, check your on/off pin for damage. Check your sear and bolt for wear that would prevent the bolt from catching properly. Make sure the body is sitting down on the rail properly. If it is not tightened down securely or if something is not allowing it to fit tight, then that could cause the auto problem as well.