Warp Feed Sensitivity?

[Zedthephish]

Well, I just bought a Pro-team warp feed, and while setting it up I discovered I have a problem. Setting the warp on the vibration mode and putting it at its most sensitive setting, I found that my automag did not have enough vibration to fire it. I'm using a classic valve. What do I do?

[nate2k191]

everything u ever wanted to know about warp: http://www.havoc-online.com/11575.html

[Zedthephish]

Sorry. I checked Havok's warp thing. It didn't help.

[RRfireblade]

Are you using teh PTP warp sensor plate? Does it activate at all,like if you hit the plate directly?

[brianlojeck]

I was under the impression that the pro team warp feed wasn't supposed to be set for "vibration" but for "external sensor/intelifeed", and connected to the sensor in the mounting plate.

a classic valve has MORE then enough vibration to activate a warp.

Here's a question, when you set it to FULL sensitivity, does it run on it's own? if not, I suspect there's something else wrong (batteries dead?)

[Zedthephish]

Yeah, when I set it to full sensitivity it runs on its own. I discovered the problem when I was trying to optimize the warp to my marker.


I think brian is right about the plate, it's got a wire and an input plug sticking out of it so i don't think it's for vibration. The person I bought it from had done some modifications to it. I know he put in an on/off switch, set it up to use 2 9 volts and put in a 12v regulator so as to not fry the board.

On the bottom of the circut board container(The black thing on the back, if what I said isn't right) there is a white button that, when pushed, spins the wheel and activates the warp, so I know there are good batteries and that it works, It's just the vibration reader that seems to be messed up.

[RRfireblade]

That's what I'm talking about. The PTP uses an external sensor plate.They have been known to go bad and/or lose sensitivity.That may be where the issue is.

[Zedthephish]

So assuming that the PTP has gone bad, what do I do about it? And if I have to replace it, how much is it going to cost?

[Zedthephish]

Upon second look, the PTP has a wire sticking out of it, is that supposed to be plugged into the warp? and if so, where?

[�?�� �m���]

Try intellifeeding it for a second option

[nate2k191]

like smerf says - and there are some really nice deals goin on in the classifieds. take a look - i seen em for 65

[Zedthephish]

If I had 65 to spend on an intelli right now I'd do it. But unfortunatly, I do not.

Anyone who wants to chip in and, you know, buy me an intelliframe is more than welcome

[RRfireblade]

Upon second look, the PTP has a wire sticking out of it, is that supposed to be plugged into the warp? and if so, where?

Sensor input. :) You may have to change the internal jumper position for it to work correctly.

[Zedthephish]

Change it to what?