You didnt say that. I said that. You wanted to use a nail or "something". Those I would say are your best two options though, drill it totally out and retap or anchor the smaller screw. Hope it works.
-
"Your just a myriad on inner conflict aren't you?"
Good Traders: deathstalker, Der Cockermeister, Target, brtncstm160
Bad Traders: None, yet..........
"I have to think of some creative quote to put here don't I?"
Feed Back:http://www.automags.org/forums/showthread.php?s=&threadid=119588 -
i ment a screw , but i said a nail , cuz he's not gonna find a tap that small
Comment
-
Well, the only reason i wanted to close the clammy completely is so i could turn the gun on/off easily. But instead of closing the gap between the two sides, i just raised the on/off using 2 tiny a$$ nuts. It was hard as a bia to put the screws into the nuts and then screw them in, but i did it.
Id like to thank everyone that tried helping me, you are why AO is so good.
Comment
Comment