Xvalve lvl 10 issues!pls help!

[Link44]

my velocity is way up, and i'm using the red spring, and if i lower the velocity, the gun chuffs, whats wrong w/ my gun? and how do i fix it? thx and its an RT Pro w/ ULT.

-Link44

[temilotzin]

Assuming your velocity is up high enough make sure you have plenty of lube on the bolt and lvl 10 white o-ring and give that a try. If that does not do it try the next size up carrier (You want the largest carrier that does not leak). If all else fails use the small spring.

[Link44]

thx

i lubed up well. so its not that. i'll try the carrier thing. keep them coming if theres any other suggestions. thx in advance!

-Link44

[Link44]

i changed the carrier size, but i don't know my velocity setting as of right now, but i think its still high. if i go to the chrono and its too high and the next carrier up leaks, what do i do?

[ICOM]

drop in med spring

[Link44]

w/ the the carrier that leaks?

[temilotzin]

No, put the biggest carrier that does NOT leak and if you cannot get the velocity low enough with the longer springs put the short one on.

[Link44]

k thx alot guys!! i'll tell u if it works or if i have any more problems

[kopfjaeger]

Is the red spring the high velocity spring or is it the gray one?

[kopfjaeger]

Is the red spring the medium spring or is it the gray one?

[11_Mile_TMaster]

Keep in mind... if you are going up in carrier size you MIGHT have to replace the carrier O-Ring, especially if you force the marker to cycle by cranking up the velocity.

[D-Block]

Red-high
Grey-Medium

[dukduk]

if ur bolt isn't resetting add a shim

[athomas]

Spring size:

Grey = stiffest
red = medium
gold = lightest

Get the marker working with the shortest (gold) spring first. Then put the next size spring in. and increase the velocity setting to bring the gun back up to operating speed. The gun should stop cycling approximately 20 fps below your operating velocity when you have the proper spring in place.