Finished my Pneumag.

[fdjizm]

finished my pneumag cost me $82.50 and some dremeling


the vid:
My Pneumag

[Pyroboy597]

That, is a nice pneu-mag.

[fdjizm]

not done yet, cant really walk it with 2 fingers good, due to no trigger stops, thats why im ripping on it with one finger, plus still waiting for my asa it aint done yet, but it shoots :)

[Webby]

Mind sending me the video via email? I'm not a member of Jayloo, and well I don't need another account setup at another random website. Email is in my profile

Thanks

[Dawg047]

Wow, could you send me a PM or email detailing exactly what you did, step by step, if you don't have the time, I understand but I would apreciate it greatly. Thanks

[patrice]

does it always bounce like mad like that

[fdjizm]

does it always bounce like mad like that

it actually doesnt bounce at all i was basically vibrating the trigger with one finger.. the motion and sound in the video is a bit off, there is no bounce or reactivity its a 3-way from fabco msv-1
the pull is like 1mm its very easy to vibrate one finger on it, i couldnt walk it like normal cuz i have no trigger stops and i overstroke it, making me walk slow.. so once i get stops ill be able to shoot like that with 2 fingers,, pneumags rule

[Dawg047]

Umm, what kind of ram are you using if your using one? How well does it fit? Any modding to the frame to get it to fit?

[fdjizm]

Umm, what kind of ram are you using if your using one? How well does it fit? Any modding to the frame to get it to fit?

i used a clippard mpa-3 it fits finer u have to just dremel the sides flat a very little...and i dremeled a little off the inside of the frame also..and it fits in there nice, also u have to cut about a 1.8 of an inch off the front of the whole piece, its to long unmodifies, theres a clip ring in it, u cut like almost down to the clip ring, and it gives u good clearance

[thirdturtle]

Tried trace back your parts list to the manufacturers... and Imagine WHAT you did... but I came up seriously short. If you could email me with a detailed process of what you did, or direct me to the thread that I should be looking at but can't seem to find.... That'd be noice.

thx

[temps]

Tried trace back your parts list to the manufacturers... and Imagine WHAT you did... but I came up seriously short. If you could email me with a detailed process of what you did, or direct me to the thread that I should be looking at but can't seem to find.... That'd be noice.

thx

http://www.automags.org/forums/showthread.php?t=173101

this may help

[warbeak2099]

Have Luke install stops. That'll solve your problem.

[thirdturtle]

Um... Yup....

That was exactly what I was looking for. Thanks.

[fdjizm]

really finished =) heres a quick vid

http://www.jayloo.com/videos/show_vid/2222.html

[ultralight]

classic valve, stainless PF body, kind of a sleeper. i like it.

very cool. how do you like the splinter trigger?

also, you say it cost ~86.00. which parts is that including? just the ram 3-way, and reg?