electo-pneumatic shocker framed mag -- its done!!

[temps]

It took a while but me and my buddy Jeebs finally finished the mod on my mag

First pics! Then details







Thanks for jayloo.com for hosting

Details:

mini-mag body
clasic valve
03 shocker frame modified to fit on the mag
mini-morlock
mpa-3
stock 03 cocker lpr

[personman]

wow, it looks great. How about some pics of the innards?

Now get a ULE body and an xvalve and you can REALLY confuse some people!

[temps]

the pics of the innards didnt turn out very well.. and there is very little see since the mpa-3 and solenoid is all up where the shocker solenoid should be.. all you can see is the board some wires and tube..

[m-a-r-k-7]

The holes lined up perfectly? odd...


and now off topic, where did you acquire that T fitting?

[BigEvil]

The holes lined up perfectly? odd...


and now off topic, where did you acquire that T fitting?

No they dont, I have a shocker frame I was going to try this one as well. You also have to possibly mill some of the back of the frame down to fit the rear field strip screw.

What solenoid did you use?

[afortuna]

How durable are the parts attached to the on/off? Is it something that would survive a paintball shot or two if hit during a game?

[luke]

and now off topic, where did you acquire that T fitting?

You can buy them at mcmaster-carr

[m-a-r-k-7]

Thanks luke, I was looking but couldnt find any, guss I have to look harder.

[temps]

the holes of the frame do not line up perfectly.. but very close.. just went at the back hole on the frame with a dremel untill it fit.

I used this solenoid from air soldier this one is small but I would recomend finding a different one that can handel a higher input pressure

And the T fitting, i'm fortunate enough to live 2 minutes away from a pneumatic parts distribution center.. they hold clipard and a bunch of other brands

[luke]

Thanks luke, I was looking but couldnt find any, guss I have to look harder.

I can't give you a direct link or I would, the mcmaster site dosen't work like that.

On the left hand side of the page at http://www.mcmaster.com/ in the "find products" box type in "brass tee".

The search should bring up what you are looking for, it's in the top row, far right...

[wjr]

You can also buy them from pamlers pursuit. Thats where I just bought mine from.

[BigEvil]

The search should bring up what you are looking for, it's in the top row, far right...

FYI to all - the nice looking ss one in the pic is not high enough to allow a LPR to sit side-saddle on the mag valve. The square brass one is. (Learned form experience :-0 )


Oh ,and btw, this noid would make a suitable replacement.

http://www.airsoldier.com:8080/cgi-bin/mivavm?Merchant2/merchant.mvc+Screen=PROD&Store_Code=AOS&Product_Code=SMC-SY113A-SG-PM3&Category_Code=SOLENOIDS

Its the one I used in my E-frame. It can handle up to about 80 psi. If that is not enough to move the on/off pin, I would suguest either a ULT, OR, using a emag quad oring in the on/off top to replace the small center one.

[m-a-r-k-7]

Thanks for that tip BigEvil, I was thinking about doing a similar project, but with a different frame, and I wasn't sure If there'd be enough room for everything with a larger noid.

[Liquid Plummer]

Nice mod. What do you figure was the total cost involved?

[nate2k191]

try to get a video of it. do you have a digital camera or anything?