electo-pneumatic shocker framed mag -- its done!!

[JaredC]

I want to do a similar project because I have an excess of shocker parts and mag parts. How do you get the shocker board to work in this? Can you please let me know what parts I need? I am far from an engineer so the more detailed the better.

[temps]

I didnt use the shocker board, I used a mini morlock.. If you were to use a shocker board you would need the upper board also.. then hook the upper board up to a solenoid some how...

As for what you need.. board of some kind.. mini morlock is good for this since its small, solenoid that can handel atleast 90 psi the more the better but you have to look at how much it can handel vs its size since there is only so much room in the shocker frame, mpa-3 to use as a ram, an lpr, random fittings (depending on how you hook up the lpr).. hose.. and screws..

As for directions what i did is a took directions for a regular pneumatic frame and instead of a mechanical 3 way, you put an electric one with a board

[JaredC]

OK, i am going to try this with a shocker (nerve) board since I have an extra one that has been sitting around. So all i would need is the upper board and a noid? The upper board is small so i can't see how it would be a problem to fit it in, and I got my last one new from SP for like $10.00. What kind of noid would be my best option and where can i get one? Will the noid and upper board connect rather easily? Once I know where to set the noid to trip the sear how do you propose setting in place? Sorry if i sound like i am picking brains, but i wanted to do this mod for a while, and i had no idea how to start.

I didnt use the shocker board, I used a mini morlock.. If you were to use a shocker board you would need the upper board also.. then hook the upper board up to a solenoid some how...

As for what you need.. board of some kind.. mini morlock is good for this since its small, solenoid that can handel atleast 90 psi the more the better but you have to look at how much it can handel vs its size since there is only so much room in the shocker frame, mpa-3 to use as a ram, an lpr, random fittings (depending on how you hook up the lpr).. hose.. and screws..

As for directions what i did is a took directions for a regular pneumatic frame and instead of a mechanical 3 way, you put an electric one with a board

[afortuna]

Not to beat a dead horse, but

can this frame handle the innards non-electronic? Just the pneumatic parts in other words. Thanks.

[temps]

can this frame handle the innards non-electronic? Just the pneumatic parts in other words. Thanks.

If you can mount it, I would think so.. But I have never seen an msv-2 so I'm not sure on what the size is.