Walkable Pneumag???

[DanMan]

lets get some pics of the first pneumag!!

[Empyreal Rogue]

What i've found trough trial and error is that the short stroking is caused by the gap between the MPA-3 ram and the sear. There should be a gap between them of about 1/8" Look at the gap as if it were dwell time, the larger the gap, the more dwell you have. Making the space to small results in short stroking the gun when rapid firing.

Thanks Fix, I'll definitely try this out as soon as I find an allen wrench small enough to fit the set screws holding my MPA in.

I still haven't found my camera. I think one of my younger sisters borrowed it and still has it. But when I do find it I'll take some pictures of my frame to see if any of the true pneumag techs see any suggestions for improving the pull a little.

[flyingpootang]

What i've found trough trial and error is that the short stroking is caused by the gap between the MPA-3 ram and the sear. There should be a gap between them of about 1/8" Look at the gap as if it were dwell time, the larger the gap, the more dwell you have. Making the space to small results in short stroking the gun when rapid firing.

Yup a key fact that is over looked....

[Thotograph]

This makes me want to build one really bad. I'm thinkin a Chimera so I can go sleeper. What other frames have been used to good effect? I bet the ripper fits it in there, anyone see a triton used? So question is it highly possible to have a walkable sleeper pneu, I'm guess only the 90frames will give enough room. I like a slightly stiffer trigger than most so I'm good with a medium tension setup. Now to find the right frame...

[RangerX]

just sleeper'd my airwalk v2. I need to install a trigger stop though

[flyingpootang]

This makes me want to build one really bad. I'm thinkin a Chimera so I can go sleeper. What other frames have been used to good effect? I bet the ripper fits it in there, anyone see a triton used? So question is it highly possible to have a walkable sleeper pneu, I'm guess only the 90frames will give enough room. I like a slightly stiffer trigger than most so I'm good with a medium tension setup. Now to find the right frame...

The pneus will fit in almost any frame. luke can do the milling, Cyberave or mann can supply the pneumatics. Take a look at Josh's electropneu conversions......
http://automags.org/forums/showthread.php?t=233176

http://www.automags.org/forums/showthread.php?t=233134

[snoopay700]

I finally got mine completely done and i was surprised at how light the trigger is, i barely brushed it and it went off, now all i need to do is fine tune it and put my own ghetto mag mod on it.

[�?�� �m���]

Here was mine!

http://youtube.com/watch?v=nCbYKE6UF08

Still have it!