Is there any reason not to buy a Micromag? Can anyone tell me what common problems they have, if any? Can i expect a good quality product? I know the valve is AGD but how does everything else hold up? work? etc....?
-
:cool: :D AO member 4 life :cool: :D
-
Mine has held up fine..... Some of the microemags have had problems with tolerances, but my microRT is fine.-Gig 'Em Ags! -
Just don't over tighten anything and you'll be great. I over tightened my gas thru grip and stripped out the hole. Other then that my Micro RT has performed flawlessly.Sorry, I'm oldComment
-
The only issue I've had with Micromags is the ball dente and the trigger (this was before retro valves came out).
The flapper ball dente was a great idea but I've had instances with double feeding. We managed to correct this by melting the dente a little to make it longer. Also, if you were to put a warp on it, there could be a chance that double feeding instances might increase.
The trigger I found to be a little sloppy. It had a lot of give on it, both front and back and side to side. I found this to be especially noticable with the double trigger. This may have been corrected with the retro valve or newer models of the Micromag.
Just my 2 cents.
Comment
Comment