update
well the update on this project is good and bad.
i have everything setup and ready to go for getting the first production board out to pual for x-mod testing. All the desiging and general testing has been done.
BUT i did run into one serious problem. The laptop that had all of my board design files, cnc files, and that also controlled my cnc took a hit during a lighting storm. the power supply died, the mother board fried, and the harddrive was killed.
I currently have the harddrive out at a high tech place to recover the info from the disk. So i should have it back by the end of next week and i will be back in business.
so to anyone reading this please please please take one thing from this. ALWAY ALWAYS ALWAYS use a surge protector with all electronics. or you will regret it.
-Chris
well the update on this project is good and bad.
i have everything setup and ready to go for getting the first production board out to pual for x-mod testing. All the desiging and general testing has been done.
BUT i did run into one serious problem. The laptop that had all of my board design files, cnc files, and that also controlled my cnc took a hit during a lighting storm. the power supply died, the mother board fried, and the harddrive was killed.
I currently have the harddrive out at a high tech place to recover the info from the disk. So i should have it back by the end of next week and i will be back in business.
so to anyone reading this please please please take one thing from this. ALWAY ALWAYS ALWAYS use a surge protector with all electronics. or you will regret it.
-Chris
Comment