Do any of you know if/where I can buy just the fitting for the input of a tickler? If not, do you know what type of threads are on the end that screws into the reg body? I can probably have some made.
Thanks,
Ben
Thanks,
Ben
-
Technically the input would be to bottom of the LPR which is a 1/8" npt.Originally posted by bbotts77
The outlet, where the barbed fitting would go is a 10-32 threaded hole and BE is correct, ASP should have what you need but if you are only looking for one PM me. I may have one for you.
LMK.......You know you want one!! -
Yes. The input (bottom) fitting is what I am looking for. If I can't buy them, I'll get one of my father's machinists to make some for me.Originally posted by Loguzzzzzz
I know the small end of that fitting is 1/8 NPT male. What I need to know is the big (top) end of that same fitting.
I can probably give it to the machinist and he can figure it out. The last time I did that, he cut a little too deep on a fitting and it burst when I aired it up. That was a combination of a language barrier and too little information.Comment
-
I understand what you are looking for now.
Pneumagger knows what thread it is, he was making adapters for the G-Force frames at one point.
Here is a link to his thread, it is an old one but I am sure he can help you. Pneumagger's thread
What are you trying to do with this,if I may ask.Last edited by Loguzzzzzz; 03-29-2010, 02:15 PM.......You know you want one!!Comment
-
I think I attempted to contact him via email a few months ago. He hasn't been on AO since September. I never heard back from him.Originally posted by Loguzzzzzz
I'm changing the gender on the 1/8 NPT end so I can screw a microline fitting. I modified a micro rock to allow this, but they are just a little bit too big for what I'm planning.Originally posted by Loguzzzzzz
Buying complete regs for experimentation is getting expensive.Comment
Comment