Replacement AGD Pump rods

[OPBN]

Something humorous about that?

I think Reebs ate paint chips as a kid or something? I definitely think you should prove him wrong and do a small run of these soon.....

[cougar20th]

If I am reading it correctly, it is calling for using some pretty hard stuff. Would somoene have to heat this up to bend it?

You are correct. It is hard stuff. As far as if it will bend without heating I do not know. Ive never tryed. Heating it up would help but at the same time the heat starts to mess with the hardening & temper of the part so that would have to be redone.

[need4reebs]

hell yeah i ate paint chips...wats wrong with that...haha

[need4reebs]

Something humorous about that?

yup there is.

[luke]

Production simply means I'm not going to make them with a vice and set of pliers. Each part will have the exact dimensions as the others, I made no mention of preorder, price or minimum to do a run, so, why is that funny?

[need4reebs]

Production simply means I'm not going to make them with a vice and set of pliers. Each part will have the exact dimensions as the others, I made no mention of preorder, price or minimum to do a run, so, why is that funny?

uh ok. chillax....i just thought it was funny...i still do..haha

[luke]

OK, whatever.

[OPBN]

Paint chips.

[need4reebs]

Paint chips.

lots of paint chips...haha

hey Luke im laughing at the paint chips too big Dawg.

[Cyco-Dude]

kind of an old thread, but i have a limited quantity of aftermarket pump rods available; manufactured to AGD's dimensions.

[OPBN]

kind of an old thread, but i have a limited quantity of aftermarket pump rods available; manufactured to AGD's dimensions.

Unfortunately the channel in my pump handle isn't to AGD spec....