Valve Cap Pole

[Xmagterror]

Making this pole to see how many people would be interested in a classic valve cap to eliminate their regulator.

[Patron God of Pirates]

Price is a factor

[Mercenario]

I agree price is a factor.

(Can't think of a funny pole joke)

[OPBN]

If in the $20-30 range, yes.

[Xmagterror]

Yes in the 20-30 price range

[OPBN]

Yes in the 20-30 price range

Then at least one, possibly two for hoarding purposes.

[Patron God of Pirates]

Yes in the 20-30 price range

Word

[TimmyJay]

I want 1 (and 2 depending on final appearance). Looks like you have enough interest already. Hope for some more

Just a question....I am not trying to kill a project....Could they be made small enough to fit completely inside the front valve section? I was thinking that it could be built similar to a screw in reg with the oring going in first, etc?

[big poppa fluff]

this sounds interesting but im not sure I understand the concept.....as in you would replace the charger section of the valve with a cap?

So the you would have to control your velocity with a in line reg, Correct?

[OPBN]

So the you would have to control your velocity with a in line reg, Correct?

Yes. Takes the weight off of the back of the marker. Since most people use a foregrip anyways it puts the weight there. IMO makes it better balanced. I have a pump set up with one as well as a pneu setup.

[big poppa fluff]

Yes. Takes the weight off of the back of the marker. Since most people use a foregrip anyways it puts the weight there. IMO makes it better balanced. I have a pump set up with one as well as a pneu setup.

I saw the silver set up you have with the milled down rail...wow very nice! I think Im going to start gearing my project mag towards a capped valve and milled rail.

Know anyone who does annodizing for a reasonable price?

[big poppa fluff]

put me down for 1 bro!

[Dark Side]

Could it be made to still use the original side port instead of the typical end port? I don't wish to have anymore macro hanging out than I need.

[OPBN]

Could it be made to still use the original side port instead of the typical end port? I don't wish to have anymore macro hanging out than I need.

Every one that I have still uses the valve side port...? Timmy J is the only one I have seen use a port on the back. Most people use that as a gauge port.

[TimmyJay]

I was going for an airstar Nova appearance.