Burst mode?

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • athomas
    Of course it works-its AGD
    • Jan 2002
    • 8039
    #16
    No. SHBF = Shot Buffer. The setting refers to the amount of time in milliseconds after a shot is fired until the board will start looking for the next trigger pull. The higher the number, the longer the wait. If you are getting full auto problems due to the solenoid interfering with the HES, then you may need to increase this setting.

    There is a separate SPS setting for rate of fire.
    Except for the Automag in front, its usually the man behind the equipment that counts.

      Comment

      • Woodsman
        Registered User
        • Jun 2014
        • 8
        #17
        @ athomas, hey thanks for the info that makes more sense now. Yes there is a separate SPS setting that is capped at 20. oh and one more that reads ACE 0 would you or one of your buds happen to know of an online manual or tech sheet for this particular version 3.2 Xmag?

        again any help is greatly appreciated...

          Comment

          • Cyco-Dude
            #18
            Originally posted by Woodsman View Post
            @ athomas, hey thanks for the info that makes more sense now. Yes there is a separate SPS setting that is capped at 20. oh and one more that reads ACE 0 would you or one of your buds happen to know of an online manual or tech sheet for this particular version 3.2 Xmag?

            again any help is greatly appreciated...
            x-mag manual. ace = anti-chop eye. you can have it turned off, or tuned for different paint.

              Comment

              • Woodsman
                Registered User
                • Jun 2014
                • 8
                #19
                @ athomas, thank you for the manual link.

                  Comment

                  Previous 1 2 template Next
                  Working...