One Legged T-Rex (OLTR)

[Levi]

Is there enough interest in these to do another small run of 25?

Two please! Paypal is ready whenever you are.

[scootdogss]

#8 for me classic valve and on/off.

[luke]

Is there enough interest in these to do another small run of 25?

If we do another I wont require you send an entire marker in to setup and test. I believe we have the working geometry correct on the frames so there shouldn't be a need for to check each one.

If we do a run I'll just add a page to my website in order to make it easy to get one.
I'm ready to go on production now, if we dont get at it there's no telling if or when I will get back to them.

[luke]

There were 13 made P1 and 1-12

I didn't keep track of the numbers on the paperwork unfortunately I only marked the boxes.

[audioSLAVE]

I have #6 I believe.

[zulubravo44]

Roster moved to the Armory

[goin5150]

still trying to figure it out... I know the last shot was a chuff and i was real low on air.. but i need to look further into it

[luke]

goin5150, what happened at the end of your video?

[luke]

Question If I was to anno the LPR-FG would I need to take out all internals?

Yes!
There is one part inside that can be anodized, you'll see when it's disassembled.

The frame anno as well. Once the OLTR is mounted is there any adjustment if I was to remove it for anno. Or is it just a simple fixed bolt?

Its a direct mount, one screw, no adjustment is possible. Just make sure it is sitting completely flat in the frame and should be all the way forward.

[scootdogss]

The trigger pin is a non machined part that just slides into the front of the T-Rex. It's an off the shelf 1/8" x 3/4" dowel pin. You can make a custom length one that will allow you to use your safety.

Good to know. I'll play with the trigger position with the stops and dowel length, I can move it forward so i can use safety or all the way back.

Question If I was to anno the LPR-FG would I need to take out all internals? Kind of dig the raw look, just thought I'd post here for reference.

The frame anno as well. Once the OLTR is mounted is there any adjustment if I was to remove it for anno. Or is it just a simple fixed bolt?

Craftsmanship is top notch, like that i can keep some parts raw and then dust anno others. Thanks

[goin5150]

https://www.flickr.com/gp/18973255@N05/4AVRhN

[going_home]

So fast I didnt even see the paint.

[BLachance75]

I practiced drumming my finger on the desk at work. Maybe some day I can hit 10bps.

[luke]

That was smoother trigger pulls than the first video.

[BLachance75]

I put a level 10 Classic valve in with a RT on/off and .750 pin

With my slow fingers I can't tell a difference speed wise and the trigger pull seems to feel the same as well.

My next test will be with an Anker trigger that I just orderer from Luke.