My warpless Rotor project

[knownothingmags]

I have a few projects. But if you are in town it makes conversation easier

Sent from my SM-G930V using Tapatalk

[barkingspider]

I have a few projects. But if you are in town it makes conversation easier

Sent from my SM-G930V using Tapatalk

Unfortunately I'm not In town, maybe next year for a pheasant hunt. I do understand your busy with life and projects. I'll raise a glass in hopes of taking a couple of these off your hands in the near future.

[knownothingmags]

I can travel, remind me in a pm where you are. I'll meet time

Sent from my SM-G930V using Tapatalk

[barkingspider]

Fingers crossed while breathing life into this thread...........

[knownothingmags]

hey so how did you get the balls to feed up instead of down. ur pics confuse me some.
im not at home so I don't have my rotor in front of me.

[captian pinky]

he is using the red and black pieces from a box mag. instead of pushing the paint down it pulls it up then he just made the tubing.

[knownothingmags]

he is using the red and black pieces from a box mag. instead of pushing the paint down it pulls it up then he just made the tubing.

damn how do I get just those pieces

[barkingspider]

I called dye and they sold me the parts. I ordered everything minus the battery pack in the second folder.

[jade_monkey07]

I called dye and they sold me the parts. I ordered everything minus the battery pack in the second folder.

What did it run You?

Sent from my SM-G920W8 using Tapatalk

[barkingspider]

[knownothingmags]

ill be ordering what i need then.
woop. this should be interesting.

[barkingspider]

I can send you what I have if that is easier?

[barkingspider]

Found my receipt from Dye, keep in mind I ordered two of each part

[knownothingmags]

perfect. thank you.
ill see what kinda bulk buy i can get done for those parts.

[Justus]

I ordered parts a couple years back too. Just got in my LT-R this weekend. You only need the red center-feed arm and the black cage that goes on top of it. You don't need any other parts. I ordered just those two things and, IIRC, I think it was something like $17 shipped to my house from DYE. You do have to call them directly though. No place online seems to sell those repair/replacement parts.


Those parts are literally drop-in mods to make the Rotor feed upwards, and I tested it with reballs for awhile this evening. As far as 3D printing the mods to the shell, you may be able to just print a "color change kit" if the necessary feed hole in the upper shell fits completely below the main piece in the color change kit. That way people could just drill a hole under their color kit and it would be completely covered if they wanted to go back to the standard setup. I'm not sure a 1" hole would fit completely under the color change kit at the correct spot though.