Introducing The Deflator

[BLachance75]

Any update on if you got a working prototype.

[luke]

Were getting close, been working on it everyday.

[BLachance75]

I like the sound of that.

[psunitro]

Going to save my pennies now....

[luke]

Small update.
Lots to do, starting with the easy stuff.

3D ULE milled grips, different from the originals but still 1 ounce each.
3D ULE milling the back is for maximum material removal, the back cavity is the same shape as the front.

[luke]

Machined the LPR this morning.
This design is similar to the one I already offer with some small changes.
The top is a smidgen wider.
The radius along the rear edge is smaller.
Includes the detail milling to match the other parts.
ULE milling. I was able to shave 1 ounce off the final design.

[knownothingmags]

Machined the LPR this morning.
This design is similar to the one I already offer with some small changes.
The top is a smidgen wider.
The radius along the rear edge is smaller.
Includes the detail milling to match the other parts.
ULE milling. I was able to shave 1 ounce off the final design.

ohh did you ULE the top?

[luke]

Four ule drilled holes on the internals (two on each part) and the top was ule milled.

[knownothingmags]

Four ule drilled on the internals (two on each part) and the top was ule milled.

[kutter]

You know, I was perfectly happy with an SFL and a Micromag. Then Luke had to go and produce a body that looks like a 1911, my favorite pistol of all time. So I guess I may have to figure out how to build a pneumag. At least it seems I have a little time so I can figure out why the Micro is leaking like a sieve before I dive into the deep end, again.

[luke]

So I guess I may have to figure out how to build a pneumag.

No need to learn anything this is a complete turn key pneumag as you see it.

[knownothingmags]

No need to learn anything this is a complete turn key pneumag as you see it.

and I have the kits available for the internals of the frame

[kutter]

No need to learn anything this is a complete turn key pneumag as you see it.

and I have the kits available for the internals of the frame

You two are aware that you are not helping anything, right?

[luke]

and I have the kits available for the internals of the frame

No need for a kit, it comes standard with a LPR and one of this. No tinkering or adjusting, it takes one screw to install and your done!

[IMG][/IMG]

[knownothingmags]

No need for a kit, it comes standard with a LPR and one of this. No tinkering or adjusting, it takes one screw to install and your done!

[IMG][/IMG]

oh yeah, sorry totally forgot you are offering that.
my bad did not mean to step on toes..