New Nummech Gas Thru Frame

[ScottyBeans]

these are siiiick!

[going_home]

Single trigger frame.

Nice find.

Looks like double and single are in stock too.

http://www.nummech.com/prod_cat_automag.html

[Laku]

[Ydna]

Email your mailing info to info@nummech and I can send you a new safety button! I'll see if I have any lighter springs, but not sure at that tiny size...but you can always try cutting the spring just a little shorter. Just don't go too short or else it won't work at all

[lynxkcg]

Anyone had any trouble with their safety locking up? The ball has deformed the safety pin groove on mine to the point that you can't take it off safety. The safety screw is flush with the top of the frame, I hope I have a lighter spring lying around.

[going_home]

Gap isn't super huge at least on the right side.

Nice

[jarhead86]

Dye Stickies cover it too

[capt spank]

luke's panels cover it

[Kapyrna]

Gap isn't super huge at least on the right side.

[Bunny]

Sorry about that! the gap between the frame and the grips. It looks like there may be a gap depending on the grips used on the frame.

[captian pinky]

which gap?

[Bunny]

Is the gap in the gripframe really noticeable?

[captian pinky]

The one on the asa knob when you completely remove it.

[going_home]

Which are you talking about, the one on top of theb ASA or the one in the ASA ?

http://www.nummech.com/media/prod_nmagframe/nmagframe-installation.pdf

[captian pinky]

How have these frames been holding up?? I'm getting the itch to upgrade a marker of mine...

I think Bigevil and i have had ours the longest. I actually have 2 now. I played 10 man ATL with it which is where i replaced the buna oring.


I would recommend replacing the oring that nummech provides with the agd spec urethane oring. The buna one that was used seems to be soft and gets nicked on occasion when screwing the on/off in. Also when i received the 2nd one it leaked from the piston inside the frame. as long as the piston isn't showing from the bottom it will seal. next time i have mine apart i can snap some pics. It may be easier for him to add some material to the piston for it to rest on the ledge in the frame.