Consistency Survey. And Problems! AHHH!

[Butterfingers]

Originally posted by FordPrefect
You said that you replaced the reg seat orings, did you replace the reg seat? That might be it, but I don't have a PhD in Automagology(IE, wild guess).

The two o-rings sit in the brass reg seat carrier. The two o-rings actually assemble to make the RT reg seat.

[BlackVCG]

How many barrels did you try on your gun and how many different types of paint? Just because the barrel and paint works fine on your other Mag doesn't mean it will perform the same on your E-Mag.

Are you looking at the consistency in slow fire? How much time are you allowing between shots? Is there any pattern to your inconsistency? As in first shots high, then low or vice versa.

The o-ring that sits under the brass reg. seat holder is the actual reg. seat. This is the o-ring the reg. valve pin seals on to shut off the system when it's charged. Make sure the sealing surface on the reg. valve pin isn't knicked or have dirt on it. The same for the brass piece.

I think your valve is fine, it's just an issue with the way your barrel is aligning with your gun setup. Are you feeding the gun with a Warp when you're shooting over the chrono or are you dropping in balls one at a time and firing them?

[AGD]

Better check the output pressure on your tank. I bet it has shifted to about 400 psi and is giving you grief. It's probably a screw in without an output gauge right?

AGD

[Butterfingers]

Originally posted by AGD
Better check the output pressure on your tank. I bet it has shifted to about 400 psi and is giving you grief. It's probably a screw in without an output gauge right?

AGD

Tom reads minds

Yeah, its a preset without an output gauge. Ill check it out tommorrow when I can get some air in my tank.

Black. I did not try any diffrent barrels. Only the one that best matched the only paint I had. Which admittedly didnt match well.

The gun was fed using warp, under slow fire.

No patterns just randomness.

Im gonna give Donggie a call tommorrow see what deals he can give me on a freak. For those of you that live on the island Donggie and I are gonna be at high velocity tommorrow testing out his new "super e-mag"

And if anybody from nitroduck is reading this. A very irate person by the name of Robert Yong wants his original tank back, and if I find out that this BRAND NEW tank that I bought from you has failed there will be heck to pay.

Also tom, will you be doing reg swaps for 4500 tanks?