Forgive me AGD for I have sinned...

[FooTemps]

It's ok, I don't care... AT LEAST I GET A FREE MAG!!! BAH!!!

[HyperSnyper]

If you did shave the on/off pin lower than AGD's original specs, then you can anticipate any sort excellerated wear to be on the bolt and sear. The length off the pin affects how the sear catches the bolt,

How? you may ask...

The sear pivots, think of it like a seesaw. If the pin is shorter, then it will allow the on/off side of the sear to rest at a higher level while the bolt section will rest at a lower position. A lower sear position with the sear means that the very edges of the 2 part will catch rather than having their entire faces catching.

In the vise versa situation, a longer pin would cause the on/off section to rest lower, and would pivot the sear so the bolt half of the sear will rest higher. This will allow more "sear" to catch the bolt face thus reducing wear.

If your bolt and sear look fine, then no worries. This tolerance dilemna is something that Centerflags spends a great deal on, they gave me a long lecture on this when I talked with long ago.

Just something to think about.

-Hyper

[HyperSnyper]

I wouldnt even consider you a traitor, so hat if you modified the pin length.

I thought you sold your Mag and got a Cocker.

Dont go over to the Dark side, yes... the temptations to join the dark side are great, but always remember... GOOD WILL ALWAYS TRIUMPH OVER EVIL...

J/K

-Hyper

[giblit]

when i was bored i touched mine and i couldnt fix it

[DJSOLID]

Maybe this will prompt the release of the delrin superpin.