WARNING to everyone! M.A.X. cannot anodize Automags. (Please Read)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CoolHand
    Logic Industries LLC
    • Jan 2003
    • 3769

    #61
    Recently, they have had trouble with their polishing crew doing too much, too little, etc. Jeremey told me that he has taken care of it, and given the quality of their work recently, I believe him.

    Everyone has problems with their help at some point, hopfully he's either '86ed the guy who was the problem, or put him to doing something else.

    Like I said, if you have a problem, call them and tell them. They will make it right.

    Relax, Banana Man is still dancing, the world hasn't ended.

    Ryan Shanks
    Logic Industries LLC

    Comment

    • bertmcmahan
      Not pop, it's all Coke
      • Jan 2002
      • 1960

      #62
      I think you misread a zero in there, that was .0002 to .001. But thanks for the info, anno has always been somewhat mysterious to me.

      On a side note, should you strip anno before applying a hydrocoat? And if I simply remove all the anno from my rail, would it screw up the tolerances? Not adding more, just stripping.
      AIM-bertmcmahan
      My email:[email protected]
      My feedback thread
      Good traders: richie,Roguefactor,moufo48,845,brtncstm160,vf-xx

      Mags don't shoot darts... they shoot nails.
      I used to be bertmcmahan, that I did.

      Comment

      Working...