Still need any beta testers?
-
-
You bet, I'll PM you...Comment
-
hey if you still need some beta tester i might be interested in the vert modComment
-
I'll pm you...Comment
-
hey, i thought of this idea a few months ago, but never had the chance to test it or post here (i'm new) cuz i dont have a mag. oh well. i cant figure out you mounted the necks with the little bend in it though, and how clean the weld is, if yours are welded that is. lookin good though and i bet they work great. when i get a mag, i'll have to have you do mine, cuz i know i wont be able to get it to look so nice. great job and i envy your mill skill
upgrade fund: $145
Comment
-
Its 2 pieces TIG welded together, then milled on the end that gets TIG welded to the body.i cant figure out you mounted the necks with the little bend in it though, and how clean the weld is, if yours are welded that is.
Check this out> http://www.automags.org/forums/showt...=155104&page=2
Scroll down to the bottom and you'll see the Vert mod.....Comment
-
I got mine and love it. Luke did such a great job that it looks like it was straight from the factory with the off-set feed. The inside of the feed tube is also incredibly smooth so no worries on cutting balls on any welds. I can't even really see where he put the body and feedneck together at since the glossy powerdercoat covers it all.
The only problem I've had to far with it is finding a way to get my hopper on it. I tried putting a rev. over the feedneck and then using a clamping ring to hold it on, but it just looks too chessy. So now I'm going to look into getting a feedneck for it. I found that any vert syder feedneck would work on it. Also a warp adapter sides right on. Thanks again Luke. It looks really nice.Comment
-
Comment