Do you know where I can find...

[BuyMyMag]

This is hard to explain, but i want to make something to clean my gun with. I have a spare tank, and a remote. I am in need of a part that screws onto a fitting, and you press it to release air. Im drawing a diagram in paint to better help you understand. Do you know where I can find one of these?

Edit:

[Bejita]

Dude......If you wanna use your spare as a mini compressor, just go to home depot and get some fittings and an air blower. But it will run out in no time because of your tanks output.

[BuyMyMag]

the diagram is up...maybe someone can help

[paint magnet]

You can release air with either a pro connect or a slide check.

Or, you could use one of these and a standard quick disconnect.

*note*
I've never actually ordered anything from either of these sites, I'm just posting them for reference. Hope this helps.

*edit*
Now that you posted the paint drawing, I see you meant something different...anyway, like Bejita said, you're going to need a bigger tank if you want to do that. Go ahead and buy a cheap compressor and an end that's made to do that.

[BuyMyMag]

thanks for the links

http://paintballgateway.com/st1onva.html

is most like what I need, but this one would release air alot at a time and not concentrated. If there was something like a needle on the end it would work.

[BuyMyMag]

They sold something like what im making on pbgear and it had a co2 tank on it.

[paint magnet]

If you want the output to be smaller, you could put a microline fitting and/or hose on there.

[BuyMyMag]

You know what you have at your kitchen sink? I want something like the sprayer that releases water you use to clean the sink or whatever. Like it has a trigger and you can release a bit at a time if you want to.

[punkncat]

Seems to me like you could buy an air nossle attach your rig to a regulator and voila....

[BuyMyMag]

where can i buy the nozzle?

[BuyMyMag]

anyone?

[Hexis]

Home Depot or other hardware stores, but it's going to be insane high pressure. You would prob want a reg on there to make it reasonable.

[BuyMyMag]

http://cgi.ebay.com/AIR-ENGINE-CLEAN...QQcmdZViewItem

would this work?

[MarkM]

The above link is the kind of item you are talking about...be careful though as the nozzle must take the pressure you are putting into it....the paintball store version had a regulator used. The fittings would certainly have to be changed. I have an Old Maxflo set up for CO2 that I thought about doing the same thing attached to a 20oz tank. I even bought a Air gun kit off of ebay but kind of lost interest in doing it.

[eric_503]

http://www.inflationzone.com/products/index.htm

this is basicly what you need i think hope this helps