Cyborg Milling... AO, how much is this worth?

**mag_lover05** · 05-31-2007, 04:37 PM

looks real clean

**behemoth** · 05-31-2007, 04:38 PM

a dollar.

**slade** · 05-31-2007, 04:45 PM

Originally posted by behemoth

a dollar.

a thousand.

current average:

$500.50

**neppo1345** · 05-31-2007, 04:49 PM

Not so much that Josh begins pestering me for monies I owe him.

**behemoth** · 05-31-2007, 04:53 PM

Originally posted by neppo1345

Not so much that Josh begins pestering me for monies I owe him.

You, and Lenny both.

**going_home** · 05-31-2007, 05:14 PM

Originally posted by slade

it still needs a bit of sanding and finishing before it can be ano'd. how much do you think I should charge?

Heres what DC charges:

**Rudz** · 05-31-2007, 05:19 PM

atleast 300

**behemoth** · 05-31-2007, 05:27 PM

You guys are killing me.

See, colin, what they meant was, "free"

**slade** · 05-31-2007, 05:33 PM

Originally posted by going_home

Trust me, I'm well aware of what DC charges.

I'm not DC.

**mag_lover05** · 05-31-2007, 05:35 PM

lol you could get a couple hundred i think. you work looks good

**Rudz** · 05-31-2007, 05:36 PM

its for josh? 700

**wjr** · 05-31-2007, 05:54 PM

What exactly do you mean by "finish". Did you sand it?

**Warwitch** · 05-31-2007, 06:42 PM

I like what you have done, very understated

Clean lines.

Id say $250

**WenULiVeUdiE** · 05-31-2007, 06:52 PM

$15 or 20 an hour plus tooling and supplies.

I am aware that is well below the average rate of a machinist.

Comment