Aftermarket X-mag Ace Boards

[Chris Nearchos]

update

just updating that the 1st & 2nd batch went out the door. everyone in those batchs should have their tracking numbers via email. also posted within their paypal statment.




also, only have enough supplies for ........ 4 ...... more complete boards with plug and play harnesses. due to only having 4 harnesses left. but i have plenty of everything else for anyone who needs a replacement or already has the signal jumper.


thanks,
-Chris

[Chris Nearchos]

update

just updating that i am down to only 2 boards left. so if you been holding back from getting one, might want to jump for one now.


thanks,
-Chris

[Chris Nearchos]

update

just updating that 1 is pending atm.


So only 1 left for grabs!


thanks,
-Chris

[AJoe]

Got it today looks good, ill attempt istall tonight.

[mostpeople]

Just want to give a thanks to Chris Nearchos again for stepping up and providing a product long out of production from AGD to keep our markers running. I look forward to working on new ideas with you in the future!

[Chris Nearchos]

glad i could help!

I am glad i could help out with such a hard item. But i am more thankful for you guys being patient while i got them designed, tested, and produced. And i deffintly want to thank you mostpeople for your help with getting the project off the ground.






I want to stress on point on the boards when you guys install them.

MAKE SURE THE EYE DOES NOT PROTRUDE OUT INTO THE BREECH AREA! OR IT WILL GET CHOPPED/DESTROYED BY THE BOLT! if it is a tad to long, just take the eye out of the socket and trim a bit off each leg and install it back into the socket. MAKE SURE TO remember the position of the eye (the flat side) when sitting in the socket. it must be in the socket as it came to you.


Thanks to all that bought the ACE setups. If you have any questions or concerns, please feel free to PM me and i will answer them ASAP for you.

-Chris

[Chris Nearchos]

question

been asked about the question of using dark paint with the eye.

what i have found with testing is that dark color and light color paint dont really matter. it actually came down to if the ball was coated with its goo or not. meaning if the ball was wet or dry on the outside. what i have come to find is that the externally dry (usually older paint that has been sitting)....the eye will not get as much bounce back compared to a good fresh goo ball.

BUT

Either case, my eye system still picks up the ball in the breech. so honestly, it doesnt matter if you use old or new, dry or goo paint.


happy shooting!

-Chris

[Chris Nearchos]

update

I have sold the last of the complete ACE setups.


I am down to my LAST ACE board for sale. It has both the ACE eye and Switch ...BUT does not come with the plug and play harness.

I will offer this one at $48.00 shipped to anyone wanting it.



thanks for looking,
-Chris

[Mrturd]

Hey Chris, please clear your inbox.

Sent an ACE board your way for repairs and verify with you before paying

[Chris Nearchos]

Hey Chris, please clear your inbox.

Sent an ACE board your way for repairs and verify with you before paying

sorry about that. Box has plenty of space now. shoot it my way again.

-chris

[gommie404]

solder details

Chaps can some one do me a big favour.

i need to re solder my pc harness back to my ace board,

but for the life of me i cant remember were they go,

can some one take a photo of there ace board for me or draw a pictrue for me.

cheers chaps