Luke's Armada Rails

[luke]

Sweet! Nice finish work, where did you get it done?

[Cali_Mag]

Thanks Luke! Its a local shop here in San Luis Obispo, Ca. Its called Hydro-it Graphics. They sell DIY kits to if ya got the time to try it yourself. www.hydroitgraphics.com is the website, dude just started te shop mid Oct. so i dont know how quick his online turn-around time is.

[swe_crazy]

Got The things earlier in the week. A little unsure if I will use the rail for this build, but this is how this combination looks.

[BTAutoMag]

I was gonna throw that very same build toether tonight to see how it looked... I'm not diggin the ledge

[BLachance75]

I like it. I think that combo makes both the body and rail standout. The ridge between the 2 breaks it up nice.

Does anybody have a Ripper body that they can put on the Armada rail?

[maverick13]

Here is what I did with mine !
Simple, but I think it looks good with the body

[luke]

Cool, thanks for the picture.

[manwe33]

Any chance you have any of these left?

[luke]

I do have a few, what were you looking for, AM, RTP with or without pump milling?

[djinnform]

get some!

[TyeStick]

Nice! I see you finally picked one up! ^

[tolar250]

got one nearly done (just need ano) and just about all the parts for the other.

[luke]

Very cool thanks for the pictures.

[luke]

I was thinking about doing a run of RTP Armadas, 9.1" long. The first batch they were all AM length.
If there is interest and I can pre-sell 15 units I'll do them. (RTP only this time).
It would be a limited run of ONLY 15, that is how many slug rails I have to machine this design.

[luke]

Pricing would be the same.