New Board

[dIVEANX]

Yes it has a tourney lock It is a dip switch on the board

Yeah he got there like 4 on sat

[coach10ef]

i just read the post,

fantastic idea to put eyes in e-mag.

it's possible to put in a e-mag with powerfeed ?

it is possible to send in France

[tae]

it's possible to put in a e-mag with powerfeed ?

Sure. The only work on the body is milling a hole for the eye to look through.

This sounds very awsome. Count me in.

[coach10ef]

are you a diagram where put eyes with powerfeed ?

[dIVEANX]

We are not going to do any eyes. Eyes will be up to the end user. We will just give you the ability to use them if you chose to

[KayleAGD]

Sorry for the slow update I just saw this thread.

The ACE board also holds a mos/fet and the on/off switch for the x-mags so the eyes only send a signal for a true high to the board. The two extra wires are only the +5v and signal wire.
I think I have all the components to repair these boards if it would help

[coach10ef]

[dIVEANX]

The best I can tell you at that point is to contact someone like Logic Paintball or TAG and ask them if they would know how or where to do it.

[BigEvil]

Eric - twist lock/powerfeed = yuor beat. Sorry bro.


As far as milling goes, I say lets draft Luke and see if he can handle it. He has lots of experience with mags, and I bet he could do it.

[Rudz]

eh

Eric - twist lock/powerfeed = yuor beat. Sorry bro.


As far as milling goes, I say lets draft Luke and see if he can handle it. He has lots of experience with mags, and I bet he could do it.

i thoyght dc was already doing the milling....and as far as the powerfeed/ twist lock, only if u drilled thru the body and barrel..and the barrel was fixed..then the eye might be able to go in the rail/ frame..but you wouldnt ever be able to take our barrel off..

[hitech]

Hey, Im interested. The only way I can do eyes is with the ACE type board as I have a warp ULE body on an eMag.

I second getting luke to do eye milling\installs. He does excellent work.

[BigEvil]

Hey, Im interested. The only way I can do eyes is with the ACE type board as I have a warp ULE body on an eMag.

I second getting luke to do eye milling\installs. He does excellent work.

Dive says the eye should be modular, so I would imagine it will work with just about anything.

[hitech]

For twist lock barrels couldn't you mill a slot in the barrel like the one for the twist lock. Only this slot would go all the way through, and of course be positioned for the ACE eye?

[Rudz]

yup

For twist lock barrels couldn't you mill a slot in the barrel like the one for the twist lock. Only this slot would go all the way through, and of course be positioned for the ACE eye?

thats kinda what i meant..

[hitech]

thats kinda what i meant..

I was just thinking that if the slot was shaped like the twist lock slot (in an "L") you would be able to remove the barrel...