DIY Carbon Fiber Foregrip

**Zone Drifter** · 09-18-2020, 07:49 AM

Great resource, thanks for sharing and doing some leg work!

**rawbutter** · 09-18-2020, 10:13 AM

Do you need special tools to cut carbon fiber?

**Automag Ranger** · 09-20-2020, 04:46 PM

Originally posted by rawbutter

Do you need special tools to cut carbon fiber?

Just a fine toothed blade for a saw, jigsaw or Dremel. I just had them cut it so I knew it would turn out right.

**RAT TAT TAT** · 10-08-2020, 08:51 PM

Hey, would you mind posting a picture of the bottom of the job?

So you're saying you had them custom cut to 3" dead?

**Automag Ranger** · 10-16-2020, 03:03 PM

Originally posted by RAT TAT TAT

Hey, would you mind posting a picture of the bottom of the job?

So you're saying you had them custom cut to 3" dead?

Yes, 3” even. With that, there is about 1/16” overhang, which is not an issue for me as I plan to chop off about 80% of the aluminum handle that goes inside the carbon fiber tube for a little more weight savings.

2EDB628A-EA13-4388-8F54-52D7467E8988.jpg

2E476332-3434-4623-8EAB-92554CAD5AD6.jpg

**ghostdog2019** · 10-17-2020, 06:38 PM

What cut length tolerances did you use for your piece and is that a sanded finish or the standard finish?

Thanks
Mike

**Automag Ranger** · 10-20-2020, 12:06 AM

Originally posted by ghostdog2019

What cut length tolerances did you use for your piece and is that a sanded finish or the standard finish?

Thanks
Mike

**ghostdog2019** · 10-20-2020, 11:37 AM

Thanks

Comment