Sneak Peak at AGD plaque

Collapse
  • Created by: luke
  • Published: 03-25-2013, 02:29 PM
  • 0 comments
X
Collapse
  •  

  • Sneak Peak at AGD plaque

    I'm going to machine a prototype of this tomorrow.
    Its 6061 aluminum 1/4" x 6" x 9" (approx) cnc machined not laser engraved.
    The back will be machined so it can be hung on the wall.
    I will be donating some of the funds from each sold to the AO fund raiser.
    These plaques will come with Tom K's autograph. (This run only)
    Only the number sold will be made in this exact configuration. So they may have some collector value.
    Design, machine time and materials dictate cost, not the cool factor. They wont be cheap.
    Price will be posted in new thread after first prototype is done.
    Anyone interested or did I waste my time???



    Tags: None
        Posting comments is disabled.

      article_tags

      Collapse

      Latest Articles

      Collapse
      • misc
        by Bunny
        [ATTACH=CONFIG]95577[/ATTACH]
        [ATTACH=CONFIG]95576[/ATTACH]
        02-10-2018, 06:28 PM
      • Sneak Peak at AGD plaque
        by luke
        6061 aluminum 1/4" x 6" x 9" (approx) cnc machined not laser engraved.
        The back will be machined so it can be hung on the wall.
        I will be donating some of the funds from each
        01-20-2018, 10:21 PM
      • Cool Hand Luke UMF frame
        by luke
        So I got the OK from Logic to use his UMF frame design, would there be any interest in an updated version?

        Loose plans are as follows:
        *Switch to an Intelli type trigger.
        01-20-2018, 10:14 PM
      • LcMP90 - P90 LPR - VASA
        by luke
        Coming Soon!
        No pre orders.
        Uses standard Intelli style triggers.
        Trigger pin is a standard dowel pin held in with set screws.
        AGD style safety. Everything is identical except
        01-20-2018, 10:13 PM
      • Gumshoe Rail
        by luke
        This rail design was talked about a few months back, there was some interest at the time so I went ahead and did the prototypes to test the programming. Engraving shown would NOT be standard but an add-on. Rails are ULE milled with foregrip slots. Automag rails would have a duel slot for use with both AGD style VASA's. RTP full length slot for 2 screw VASA. Both rails match factory lengths. Milled for all body styles. RTP is 1.00" wide. AM rail is 0.98" Both rails can be pump milled. ...
        06-03-2014, 07:34 AM
      • RTP Armada-L (full length)
        by luke
        Anyone interested in this 'long' version of the Armada?
        It uses the RTPro sear and matches the factory length RTP rails.
        Foregrip slot and full ULE milling.

        RHS


        LHS
        ...
        06-03-2014, 07:33 AM
      View All
      Working...