[ATTACH=CONFIG]95577[/ATTACH]
[ATTACH=CONFIG]95576[/ATTACH]

6061 aluminum 1/4" x 6" x 9" (approx) cnc machined not laser engraved.
The back will be machined so it can be hung on the wall.
I will be donating some of the funds from each

So I got the OK from Logic to use his UMF frame design, would there be any interest in an updated version?

Loose plans are as follows:
*Switch to an Intelli type trigger.

Coming Soon!
No pre orders.
Uses standard Intelli style triggers.
Trigger pin is a standard dowel pin held in with set screws.
AGD style safety. Everything is identical except

This rail design was talked about a few months back, there was some interest at the time so I went ahead and did the prototypes to test the programming. Engraving shown would NOT be standard but an add-on. Rails are ULE milled with foregrip slots. Automag rails would have a duel slot for use with both AGD style VASA's. RTP full length slot for 2 screw VASA. Both rails match factory lengths. Milled for all body styles. RTP is 1.00" wide. AM rail is 0.98" Both rails can be pump milled. ...

Anyone interested in this 'long' version of the Armada?
It uses the RTPro sear and matches the factory length RTP rails.
Foregrip slot and full ULE milling.

RHS


LHS
...