E/X Mag Technical Guide
Collapse
-
Created by:
Bunny
- Published: 03-14-2013, 07:56 PM
- 0 comments
-
X
Collapse
-
- 1. About the Emag and Xmag Valve
-
E/X Mag Technical Guide
The Emag/Xmag valve is identical to the RT/RTP/X valve(see About the RT/RTP Valve) with a different logo engraved on the outside. The valve does however require a different on/off pin length(.712") (Sear tolerance for Emag/Xmag - trigger rod 2.125", plunger rod 3.008") and a special o'ring in the on/off assembly called the "Quad o'ring". The Quad o'ring(pictured below) is seamless in the center and is used to reduce drag on the on/off pin that caused hang-ups with the standard o'ring that has a seam in the center. The drag was caused by the added weight of the sear over the RT/RTP sear.
**The ULE Trigger Pull Kit is NOT recommended for the Emag or Xmag.
Quad O'ring
Posting comments is disabled.
Categories
Collapse
Latest Articles
Collapse
-
by BunnyHere is a 4 part series about the disassembly procedure for the E-mag.
...-
Channel: Technical Guides
08-17-2013, 02:03 PM -
-
by Bunny
Originally Posted on AutomagsUK.com
The Emag and Xmag are the top of the food chain in the world of Airgun Designs. These badboys boast fully adjustable magnetic triggers, a fail-safe mechanical over-ride, ultra-low profiles, the proven anti-chop system the level 10, and the fastest recharging valve in the world.
...-
Channel: Technical Guides
03-14-2013, 07:56 PM -