BacciPaintball: Breaking Down a Level 5 Automag:

Collapse
X
Collapse
  •  

  • BacciPaintball: Breaking Down a Level 5 Automag:

      Posting comments is disabled.

    article_tags

    Collapse

    Latest Articles

    Collapse

    • 68 Automag GIFS
      by Bunny
      [ATTACH=CONFIG]95514[/ATTACH]

      [ATTACH=CONFIG]95513[/ATTACH]
      02-10-2018, 05:31 PM
    • 68 Automag Patent
      by Bunny










      Adobe PDF of the Patent:
      ...
      02-10-2018, 05:25 PM
    • BacciPaintball: Breaking Down a Level 5 Automag:
      by Bunny
      ...
      12-03-2014, 12:33 PM
    • Serial #'s: 100-200 Automags
      by AGD
      What did I just buy? AGD Historians help me out Well for sure its the 48th gun made. We started at 100. The manuals and the brochure are newer though and make it a little suspicious since that stuff usually went with updated guns. The black hose is original as is the back bottle adaptor. The co2 tank is also a period piece and I would pick that up too. The first 100 guns went to Bill Hansen in Michigan because he was ready to pay cash for them all. I think it would have been unlikely...
      09-07-2013, 09:44 PM
    • Pro Mags?
      by AGD
      Ask and I appear.... In the very first batch of mags, the front and back of the regulator were made on screw machines. The air flow hole from the on/off on the front half was always at the top where it is now. The back half of the reg had a hole drilled randomly 360 degrees in a circle that was machined into the reg body so the air would flow around and get to the hole. John Sosta figured out that if you happened to get a reg where the two holes were 180 degrees apart, the air flow wou...
      08-21-2013, 06:46 AM
    • List of Automag Levels
      by AGD
      For all you collectors out there I happened to come across my original listing of the different levels for the Mag and what was done in each. We didn't release the gun until level 5 so previous to that you will not find any. I am posting it here so I don't loose it again! AGD ...
      03-24-2013, 03:04 PM
    Working...